@duncanidaho wrote:
I recently attempted to use my gui update to 12. However I am getting a lot of FOP, PHP and other disabled modules errors. I also am getting a security threat error that I can not seem to find answers to resolve.
I am running firmware 5.211.65-9 service pack 1.0.0.0
Following is the GUI screen errors
There is 1 module vulnerable to security threats
is 1 module vulnerable to security threat
fw_ari (Cur v. 2.11.1.5) should be upgraded to v. 12.0.5 to fix security issues: SEC-2014-002
This is a critical issue and should be resolved urgentlyThere is 1 module vulnerable to security threats
There is 1 module available for online upgrade
webrtc 12.0.2 (current: 2.11.0.0beta7) (I can't upgrade this module
config.php?display=modules
15 minutes, 42 seconds, ago
Could not reload FOP server
I constantly can not get FOP to reload
You have 3 disabled modules
You have 3 disabled modules
The following modules are disabled because they need to be upgraded:
endpointman, webrtc, xmppYou should go to the module admin page to fix these. Again I can not upgrade these modules whenever I try I get errors. This also will not install
PHP-XML isn't installed.PHP-XML is a requirement of PHP SysInfo. System Statistics are disabled until that package is installed.
This can be resolved by installing the 'php-xml' package on most distributions, and then restarting Apache
PHP-XML isn't installed.
PHP-XML is a requirement of PHP SysInfo. System Statistics are disabled until that package is installed.
This can be resolved by installing the 'php-xml' package on most distributions, and then restarting Apache
Show New
rss-0 Feed
FreePBX Statistics
PHP-XML isn't installed.
PHP-XML is a requirement of PHP SysInfo. System Statistics are disabled until that package is installed.
This can be resolved by installing the 'php-xml' package on most distributions, and then restarting Apache
Any help to get my system properly updated would be appreciate. I also want to remove security issues.
Posts: 5
Participants: 2