@erevodifosin wrote:

Hello to everyone,
I have a new installation of FreePBX 13.0.188.8 connected with a Patton 4120 2xBRI (SN4120/2BIS4V/EUI). I am mostly familiar with pci cards and not gateways, but this is a virtual enviroment and i couldn't use a pci card. I searched on the internet for something that might be usefull with a little luck.
Anyway I achieved to do some configuration at Patton and the outbound calls are working fine. But, incoming calls aren't . This is not a freepbx issue cause the inbound route routes to hold and when i make an inbound call it doesn't route me to hold, it keeps ringing somewhere.

Any help or reference is appreciated.

This is my current Patton configuration

----------------------------------------------------------------

SN4120/2BIS4V

R6.9 2016-09-01 H323 SIP

2016-10-13T10:43:06

Generated configuration file

---------------------------------------------

cli version 3.20
clock local default-offset +03:00
dns-client server 192.168.1.1
webserver port 80 language en
sntp-client
sntp-client server primary 2.gr.pool.ntp.org port 123 version 4
sntp-client server secondary 3.gr.pool.ntp.org port 123 version 4
sntp-client poll-interval 600
system hostname patton

system

ic voice 0
low-bitrate-codec g729

system
clock-source 1 bri 0 0
clock-source 2 bri 0 1

profile ppp default

profile tone-set default

profile voip default
codec 1 g711alaw64k rx-length 20 tx-length 20
codec 2 g711ulaw64k rx-length 20 tx-length 20

profile pstn default

profile sip default
no autonomous-transitioning

profile aaa default
method 1 local
method 2 none

context ip router

interface eth0
ipaddress 192.168.1.149 255.255.255.0
icmp router-discovery
icmp redirect accept
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu

context cs switch

routing-table called-e164 RT_ISDN_TO_SIP
route .T dest-interface IF_SIP

interface isdn IF_ISDN_00
route call dest-table RT_ISDN_TO_SIP
call-reroute emit
diversion emit

interface isdn IF_ISDN_01
route call dest-table RT_ISDN_TO_SIP
call-reroute emit
diversion emit

interface sip IF_SIP
bind context sip-gateway GW_SIP
route call dest-service SRV_HG
remote 192.168.1.150
address-translation outgoing-call from-header user-part fix Patton4120 host-part call

service hunt-group SRV_HG
drop-cause normal-unspecified
drop-cause no-circuit-channel-available
drop-cause network-out-of-order
drop-cause temporary-failure
drop-cause switching-equipment-congestion
drop-cause access-info-discarded
drop-cause circuit-channel-not-available
drop-cause resources-unavailable
route call 1 dest-interface IF_ISDN_00
route call 2 dest-interface IF_ISDN_01

context cs switch
no shutdown

authentication-service AUTH_SRV
username Patton4120 password encrypted

location-service SER_LOC
domain 1 192.168.1.150
match-any-domain

identity Patton4120

authentication outbound
  authenticate 1 authentication-service AUTH_SRV username Patton4120

registration outbound
  registrar 192.168.1.150
  lifetime 3600
  register auto
  retry-timeout on-system-error 10
  retry-timeout on-client-error 10
  retry-timeout on-server-error 10

context sip-gateway GW_SIP

interface IF_GWSIP
bind interface eth0 context router port 5060

context sip-gateway GW_SIP
bind location-service SER_LOC
no shutdown

port ethernet 0 0
medium auto
encapsulation ip
bind interface eth0 router
no shutdown

port bri 0 0
clock auto
encapsulation q921

q921
permanent-layer2
uni-side auto
encapsulation q931

q931
  protocol dss1
  uni-side user
  bchan-number-order ascending
  encapsulation cc-isdn
  bind interface IF_ISDN_00 switch

port bri 0 0
no shutdown

port bri 0 1
clock auto
encapsulation q921

q921
permanent-layer2
uni-side auto
encapsulation q931

q931
  protocol dss1
  uni-side user
  bchan-number-order ascending
  encapsulation cc-isdn
  bind interface IF_ISDN_01 switch

port bri 0 1
no shutdown

Posts: 1

Participants: 1

Read full topic