Use a Cisco router FXS as PBX subscriber

@FrankRadio wrote:

Hi!
I'm a little bit confuse so before start with cli commands I need a small guide.

I have a Cisco 2600 router with several FXS boards. The router hardware is ok because I'm using other like destination and have others FXS ports.

Now I need to setup it as an extension or as a trunk line ?
Sip-ua only have one registration for the same router so I don't know how to setup it for each voice-port.

Some example to follow? I treat them like FXO with out DID ?

I need to add some configuration via CLI into the freepbx or I can do using the web admin?

Best Regards!
Frank

Posts: 1

Participants: 1

Read full topic