@frouty wrote:
Hi,
My config: Sangoma appliance, ip phones: sangoma s500 et polycom vx400
vega50 gateway for one BRI line, an sangoma FXO card 4 ports, 2 analogic lines.
Cisco SG500-28P switchWhen I do :
*97 / 0 / record my unavailable message on sangoma or polycom ipphones
2 to listem to my recording sound is OK.
then call from outside , wait for the voicemail system to play my unavailable message is barely audible, but the system message like 'good bye' are OK low but OK.I have others audio problems with the analogic lines but not the BRI lines. I don't know if there could a relation with the voicemail system audio problem.
The office was closed, pc off . Except mine of course.
Where should I go to improve that?
Many thanks
Laurent FRANCOIS
Posts: 1
Participants: 1