Unable to see my X100P's in FreePBX

@eagle wrote:

I just installed FreePBX on my home server and I have two X100P boards in the computer (I have been using this computer and these cards for years with earlier versions of FreePBX), but they don't show up in the DAHDI settings in FreePBX nor in the CLI for dahdi show status or dahdi show channels - however the dahdi_scan detects them fine:

dahdi_scan
[1]
active=yes
alarms=RED
description=Wildcard X100P Board 1
name=WCFXO/0
manufacturer=Digium
devicetype=Wildcard X100P
location=PCI Bus 03 Slot 02
basechan=1
totchans=1
irq=0
type=analog
port=1,FXO
[2]
active=yes
alarms=RED
description=Wildcard X100P Board 2
name=WCFXO/1
manufacturer=Digium
devicetype=Wildcard X100P
location=PCI Bus 03 Slot 03
basechan=2
totchans=1
irq=0
type=analog
port=2,FXO

Is there something else I need to be doing to get the system to recognize my cards? I know that there's a lot of bias about the X100P's but they have worked well for me for a long time. I have a 4 port analog Digium card but just don't have it handy right now (I have to extract it from another old PBX I used to use) so i can resort to that if I must but it seems this should work if dahdi_scan detects them.

I am running the latest build of FreePBX and Asterisk 13 (just downloaded the distro this evening).

One other note, neither card is plugged into a phone line at the moment, I'm bench installing this right now.

Posts: 5

Participants: 2

Read full topic