Assistance - Engin Trunk config and dial patterns (Australia)

@DamianB wrote:

Hi Everyone,

I'm trying to get Engin SIP trunks working on my new FreePBX and struggling. being new at this I am googling lots and have watched lots of vids etc, but I'm not sure if i have been gone down the wrong track as I'm not sure how much the info I have is SIP providor specific etc.

Outgoing Peer details are currently as follows:

type=peer
context=from-pstn
host=trunk.engin.com.au
username=xxxxxxxx (actual username)
secret=xxxxxxxxx (actual password)
qualify=yes
disallow=all
allow=ulaw&alaw
dtmfmode=rfc2833
insecure=port,invite
trustrpid=yes

Incoming user details:
secret=xxxxxxxxxx
type=user
context=from-trunk

Register String: [username]:[password]@trunk.engin.com.au

I currently have no dial pattern rules in place, but can't get a call out if I dial a local number with any of the following syntax.

61 3 xxxx xxxx
03 xxxx xxxx
xxxx xxxx

I'm in Melbourne, I assume with no dial patters one of these options should work at least?

Can any Aussies assist with what dial patterns i should be using to send all of my calls out of this one trunk?

I also cannot get a call inbound either. What logs should I be showing here to help my cause? Any advice is welcome.

Posts: 1

Participants: 1

Read full topic