@baggyp wrote:
We have two companies we run out of the same office. I originally set up our PBX to just handle one of the companies but have since decided to use it for both. So I ordered a DID for the other company and set it up to where when you dial in it hits an extension. I can dial in and I see the call connect and all is well. So now I tried calling in again, and nothing… I dont see the call even hit the system… Its like its not leaving the provider. I can make it work again by deleting and rebuilding the trunk but that seems like the only way to make it work.
I built another FreePBX virtual box to see if it was the provider and its not as I can get calls in on that box no issue through the DID and settings in question. Its been up and working for 12hrs and works every time. I would actually leave it like this but my server is at a different location than my office phones and It would be an utter pain in the butt to poke more holes in my firewall and play with different ports to make this work.
Anyone ever see this before? Could it be something in the NAT or on the network side? I’m kind of lost on this… Or if someone knows a decent work around that I may have not thought of yet…
Thanks folks!!
Posts: 2
Participants: 2