IAX2 trunk for 2 x FreePBX 14

@cmstechnical wrote:

Hi All,

I am hoping to get some help. i had this working on an older version of Freepbx in the past and have followed multiple guides and youtube videos with no joy this time.

I need the most basic IAX2 trunk to transfer calls between two sites.

I have created a trunk on both sites (only outgoing as the guide suggested and ignored the incoming)

with the following

trunk name:
pbx1_to_pbx2

peer details:
type=friend
qualify=yes
host= (pbx2ip)
context=from-internal
disallow=-all
allow=ulaw

and the reverse on the other system only in outgoing.

IAX2 Info shows a peer connection on both

I have setup an outgoing route with dial plans on both and selected the trunks i created.

I am not very comfortable using the dial plans.

One system has extensions 213 - 223 and 801 to 809
The other has extensions 201 - 210

I have tried X. and just . on them both and both says all circuits are busy

Any suggestions welcome

Posts: 1

Participants: 1

Read full topic