@Terrum wrote:
I'm attempting to setup FreePBX on a VPS for a client. The VPS uses bridged networking and is configured as it should be (with the IP's MAC address, and the IP has worked flawlessly. on previous OSes that I install the same way, such as CentOS).
Upon setup I was introduced with a section that allowed me to enter my IPv4 details manually and disabled IPv6. I did this as necessary, but pinging doesn't work and 'some firstboot error occurred, and the system is not properly setup' due to no internet.
So, I looked inside the ifcfg-eth0 file which is fine
And the 70-persistent-net.rules file which is fine (justified for better view but ensured it wasn't saved)
(I can't post more than one image, but I will give the extra screenshots if required)I also looked inside etc/resolv.conf which is also fine
(I can't post more than one image, but I will give the extra screenshots if required)When restarting the network service it says everything is OK (including the IP I have entered)
(I can't post more than one image, but I will give the extra screenshots if required)But when using 'route -n' it seems to be depending on APIPA (169.254.0.0).
(I can't post more than one image, but I will give the extra screenshots if required)Pinging the default gateway does not work. It doesn't seem to be making any attempt to use the manual information I have entered.
Any help would be greatly appreciated! Many thanks.
Posts: 3
Participants: 2