Guidance on Sangoma A200 - FreePBX setup - outbound failing

@GeekBoy wrote:

Learning about setting up as I have never done this before.

Getting the following:

WARNING[5168][C-00000004]: app_dial.c:2411 dial_exec_full: Unable to create channel of type 'DAHDI' (cause 0 - Unknown)

I assume it is functioning correctly.

wanrouter hwprobe

| Wanpipe Hardware Probe Info |

1 . AFT-A200-SH : SLOT=0 : BUS=2 : IRQ=20 : CPU=A : PORT=PRI : HWEC=32 : V=11

dahdi show status
Description Alarms IRQ bpviol CRC Fra Codi Options LBO
wrtdm Board 1 OK 0 0 0 CAS Unk 0 db (CSU)/0-133 feet (DSX-1)

dahdi show channels
Chan Extension Context Language MOH Interpret Blocked In Service Description
pseudo default default Yes

In the Trunks I have the following:

DAHDI Channel g0

In the trunk "dahdi Settings" I have the trunk set to use Analog Channel 1 (port closest to the motherboard).
I did try Round Robin with same result.

Yes I did setup an outbound route pointing to that trunk.

Any guidance on how to troubleshoot why I am getting that error?

Thank you kindly

Posts: 1

Participants: 1

Read full topic