Quantcast
Channel: General Help - FreePBX Community Forums
Browsing all 12657 articles
Browse latest View live
↧

IVR pressed menu

@Bidhya wrote: Hello,I am looking for a way to track which key is pressed on IVR menus.I was able to get the call recordings in the cdr reports but could not find where the numbers dialed in ivr menu...

View Article


Image may be NSFW.
Clik here to view.

Freepbx 13 and send-to sources in Superfecta module : no longer working?

@kdaffef wrote: Hi, I'm testing vultr server with freepbx 13 image, and enjoyed really my configuration (9 trunks, 20 extensions). Just having ONE issue with Cid Superfecta (updated to last 13.0.41)...

View Article


Image may be NSFW.
Clik here to view.

Scheduled one way intercom call... best way?

@mcisar wrote: I'm trying to figure out the best way to set up an automated (handsfree) one-way intercom call from one extension to another? So essentially at 11pm extension 229 will call extension...

View Article

Sangoma S500 Call Log - Dialed Calls

@mabbaticchio wrote: Hello all and thank you in advance.On our Sangoma S500 phones when we look at the call log on the phone screens, the Dialed Calls section only shows extension numbers. All of the...

View Article

Problem with override call recording location

@amir_nassaji wrote: helloI want to change cal recording location to a directory on usb, first I mount a usb and then creat a directory in it mount /dev/sdb1 /mntcd mntmkdir monitoring then I add path...

View Article


3CX Trunk to FreePBX

@ors_86 wrote: Can we setup a trunk at FreePBX with 3CX extension credentials in order to receive and make calls ? Posts: 7 Participants: 4 Read full topic

View Article

Virtualize a running machine

@digiteltlc wrote: Anyone experienced in vmware virtualization ? I need to virtualize my running phisical freepbx into ESXi 5.5 Hypervisor Any help appreciated Posts: 2 Participants: 2 Read full topic

View Article

Group and Queue calls

@Spaxton wrote: Dear friends, I have searched a lot and so far I know that this question was asked thousand times but I didn't find any solution over the internet or in this forum... I would like to...

View Article


How can you tell if the Vpn server is running on phone server

@Red wrote: Is there any way to tell if the vpn server is running in freepbx ver 13.0.192.19 I don't have the notification that used to be with version 12. Posts: 4 Participants: 2 Read full topic

View Article


SipStation Port Forwarding on a Juniper SSG5

@KBliven wrote: I'm fairly in the PBX arena so please bear with me. I have installed FreePBX on a CentOS linux box. I am able to make calls between phones internally and need to take things to the...

View Article

Image may be NSFW.
Clik here to view.

Setting up Lets Encrypt

@eknudhol wrote: I am trying to get the CA setup using LETS ENCRYPT and keep getting the following error: There was an error updating the certificate: Please check...

View Article

Flowroute Direct IP?

@vbman213 wrote: Anybody successfully configured Flowroute Direct IP (instead of using SIP registration)? If so, would you mind sharing your steps? Much appreciated Posts: 2 Participants: 2 Read full...

View Article

Whitelist FQDN

@mhammett wrote: I saw in a thread a recommendation to use a DDNS service for remote extensions on dynamic IPs and whitelist their FQDN. The last I knew, IPTables didn't take FQDNs. Does this work and...

View Article


Outbound FAX send fail

@floriandinca wrote: Okey, this problem is really killing me...PBX Firmware:12.7.4-1710-1.sng7PBX Service Pack:1.0.0.0Device: Ricoh MP C307SPFOutbound Sip Trunk Settings: disallow=all...

View Article

Upgrade to Distro

@bradlarose wrote: I need to upgrade an elastix install which has Freepbx 2.11 and I would like to go to the Distro Freepbx 14. I want to do this on the same box so as I read I cannot use the...

View Article


In-Reply-To header Pass Caller ID on call transfer

@litmount wrote: Hello, I am trying to configure Callcentric on Asterisk 13, Freepbx 14 to allow me to transfer an answered inbound call to a cell phone/landline and pass the Original callers Caller...

View Article

Endpoint Manager Cisco Handset Support

@nxcoms wrote: Hi, Im using FREEPBX distro v14 Can you tell me if the endpoint manager module supports Cisco 78xx series and 88xx series phones?These phones have been out a while now but the supported...

View Article


Viewing Presence on Zulu

@chrisgraber15 wrote: Is there an easy way to be able to see the presence of all of your contacts? You can view the presence of each person individually by clicking on their name in the contacts page,...

View Article

Second NIC added for external access

@tty0744 wrote: FreePBX 13.0.192.19Asterisk 13.18.0SHMZ release 6.6 (Final) I've added a secondary NIC to allow me to access the FreePBX GUI, and for remote extensions, from the outside world. My...

View Article

Call File Variables

@comtech wrote: Asterisk/FreePBX 14 I've been working with call files in order to setup a treatment where the caller will call in and enter a number to be called back at. A call file will be generated...

View Article
Browsing all 12657 articles
Browse latest View live