Extension registered but can't be dialed?
@dgs wrote: Hi, I have a single extension (863) that is a polycom phone. I see it is registered when I do SIP show peers. Here is a small snippet. 861/861 10.9.78.124 D Yes Yes A 5060 OK (22 ms)...
View ArticleVoicemail issue
@StreamingGeek wrote: We are using the Voicemail Blasting feature in FreePBX. Our greeting plays fine, but the voicemail beep does not play. Instead of recording the voicemail, it hangs up on the...
View ArticleSpeed dial number?
@josephchrz wrote: hello i read somewhere in the community forum that i can make a park call as a speed dial? i don't remember where i saw it from but it said to do ##70# not sure what is that? can...
View ArticleAsterisk 13 Queued calls - FOP delay
@dsubs wrote: Asterisk 13FreePBX 13 and FOP2 2.31.03 We are having issues in FOP for Queue calls. When a call enters a queue, there is a delay in the calls getting updated in FOP. Even though the call...
View ArticleMusic on hold radio station?
@josephchrz wrote: Hello is it possible to play a online radio station when someone is on hold? Posts: 2 Participants: 2 Read full topic
View ArticleDevice hints & states after reloading config / restart not updated fully?
@el_es wrote: Hi,Current Asterisk Version: 11.23.0, FreePBX 13.0.167, FreePBX Distro 10.13.66-15, D&U mode; but I have been noticing this behavior earlier too; only could not figure out the...
View ArticleDAHDi Config 13.0.24
@tty0744 wrote: FreePBX 13.0.167SHMZ release 6.5 (Final)Asterisk 11.14.2 Upon restarting Dahdi & Asterisk, this update produces "You have new hardware! Please configure your new hardware using the...
View ArticleDAHDI hangup when transferring to extension with FollowMe enabled
@jlg89 wrote: Asterisk 13.10.0 built by mockbuild @ jenkins2.schmoozecom.net on a i686 running Linux on 2016-07-27 01:24:12 UTC I have an IVR configured that allows the caller to punch 1, 2, 3, etc....
View ArticleLost useragent
@AndrewZ wrote: Very cosmetic issue, but anyway..I managed to loose my useragent setting in the configuration, probably after the recent backup/restore.I'm using chan_sip but search for 'agent' in...
View ArticleClik here to view.
Stuck at updating license information in boot up
@Kingjohn wrote: Boot up is stuck at updating license information. Any help on how to fix this would be great. Please see the screen shot below. Screen Shot 2016-08-17 at 4.23.18 PM.png836x744 14.7 KB...
View ArticleRing Group (Destination No Answer) Not Working
@bcurless wrote: FreePBX 12.0.76.4 / Asterisk 13.2.0 Ring Group 6600 -> goes to 6605, then 6729, then 6601. If no one answers, it should end up in 6605's voicemail. Problem is, the voicemail only...
View ArticleI can't make outbound calls with FreePBX and GrandStream GXW4104
@alankis wrote: Hi everyone, I have recently configured FreePBX with Grandstream GXW 4014 FXO gateway using for now just one analong PSTN line. I have configured following along Configuring a...
View ArticleClik here to view.
PBX Upgrade Module Does not give the option for install
@DarkQuark wrote: I feel I must be missing the obvious so if someone can just point the way. I have a few V12 systems (built off the official distro) that I want to upgrade to V13. I can see the...
View ArticleCan not reload FreePBX due to 255 error (Exec(): Null byte detected)
@truongdm wrote: After reboot the server, i suddenly encouter this error while applying new config for Freepbx:Reload failed because retrieve_conf encountered an error: 255exit: 255Unable to continue....
View ArticleMake CNAM lookup also work internal trunks
@avayax wrote: Using Opencnam.As I understand it, CNAM lookup works on inbound routes.Is it possible to make lookups happen also on internal SIP trunks without inbound routes? We have most of our...
View ArticleACD key for Yealink phones
@amztransit wrote: This isn't a top priority for us, but I'm trying to get FreePBX to interface with the ACD features of our T23G phones to show the user's status, and allow them to log in/out of the...
View ArticleDAHDI card may have died
@Rudy44 wrote: Came in this morning and our incoming lines were getting "The number you are trying to reach is no longer in service....." We still have our old Siemens system here, so after moving the...
View ArticleNeed help with the Grandstream GXW-4108 FXO gateway
@josephchrz wrote: Hello I bought a Grandstream GXW-4108 FXO gateway 8 Channel I searched online to many websites and pretty much got lost. But i did mange to find this site Install guide for the...
View ArticleIncluding custom contexts
@basixs wrote: Hello,Is it normal functionality to not include the custom contexts anymore? It seems I can add contexts to the extensions_override_freepbs.conf but if I add anything to...
View ArticleCall Confirmation
@jhayes wrote: We are using PJSIP extensions with asterisk 13.9.1 with Freepbx 10.13.66-5 and are unable to use the call confirmation on internal calls. We would like to force specific queues to force...
View Article