Quantcast
Browsing all 12632 articles
Browse latest View live

QOS & TOS settings

@pigsfoot wrote: HI,I am trying to set up QOS - TOS and I'm confused over what setting i need to set. I need to set TOS as - number 6 according to this chart ( supported by my Ubiquiti WiFi connection...

View Article


Digium phones - No blind transfer via BLF keys?

@TechOne wrote: I have a few Digium D70 phones, both at my office and at a client's. My system is a PBXact system, and the client's is FreePBX. I am using the commercial EPM to configure the phones at...

View Article


Problem in Call Forwarding FreePBX 2.11.0.38

@Debashis wrote: Hello, I need help in setting up call forwarding on my Cisco IP Phone 7942. I am Using Freepbx Asterisk (Ver. 1.8.22.0)FreePBX 2.11.0.38 I have set up below config on my...

View Article

CDR selection not working

@andersonhaulage wrote: I'm stuck with a system where paging is used extensively and we have 40 extensions. I'm trying to pull CDR to exclude all the pages. The CDR shoes these entries for pages:...

View Article

Call Park position announcement

@phoneguy509 wrote: Using Grandstream 2160 and 2100 phones and GXV3240. I have a key Programmed as call park and *8670 Call comes in, I answer it. I then press call park. The call gets parked but I do...

View Article


Shut down warm backup server via SSH

@Bradbpw wrote: I have created a warm backup server using the guide in the Wiki. I have my main PBX plugged in to a Cyberpower 1350VA UPS via a USB. This shuts down the main PBX fine, but is there a...

View Article

Frequent unregistering of Gigaset N510 IP Pro Dect Base

@bleckfield wrote: Equipment:Gigaset N510 IP Pro Dect Base station plugged into Netgear gigabit poe switchFreePBX 2.10.1.19 running on a physical Asus EeeBoxAsterisk 1.8.3 on CentOS 5.5CSF firewall on...

View Article

IAX2 Link going down in one direction

@amartin13 wrote: Hello all, I'm having a problem with my PBXs that are linked via IAX2. I have two PBXs running Asterisk 11, and FreePBX 2.11. One of the PBXs is hosted by Amazon t1.Micro and a...

View Article


Custom Failover Module - Preserving Caller ID

@SteveConcero wrote: I wrote a little module in extension_custom.conf, which checks to see if a remote SIP extension's status is OK, and if not, transfers the call to a cell phone. Here is the module:...

View Article


Add localhost in Local Networks

@digiteltlc wrote: My setup uses a sip trunk to deal to Skype gateway that resides on the same machine.This sip trunk is configured this way :...

View Article

Queue: call the same agent who took our last call?

@peter59 wrote: Hello everyone, I want to know if it's possible to make a queue whose agents logged in could take a call from caller they have already taken earlier in the day? My queue configuration...

View Article

Sip Trunk Provider

@assos40 wrote: Hi,Can someone please recommend me a reliable Sip trunk provider with a europe server.Thank you Posts: 2 Participants: 1 Read full topic

View Article

Qualify Problems for Some SIP Devices

@stevensedory wrote: We're on FreePBX 12.0.76.2 with Asterisk 11.20.0 We recently realized we could not make calls to two extensions/devices. In Asterisk/Peers, the devices showed no IP, and were...

View Article


Completely disable join/leave sounds for conference bridge

@kiddbios wrote: Is there a way to completely disable any join/leave sounds on a conference bridge? We're running FreePBX distro 5.211.65-21. Asterisk version 1.8.32.2. FreePBX version 2.11.0.43. Any...

View Article

Cannot receive faxes from sip

@hydro3 wrote: Hello all I have a couple of quick questions. I have had the raspbx install going for a couple of years and was receiving faxes. However, I now converted over to a system that should be...

View Article


FTP Call Recording

@AaronGustafson wrote: Ok, so our server has a rather small hard drive (Specifically it's a virtual instance), I would like for the call recordings to be FTP transferred (with username and password)...

View Article

Unable to receive calls - outbound okay

@mkoenig wrote: Cloud based hosted at RentPBXCentOS release 6.7 (Final)Freepbx 12.0.70Asterisk 13.5.0Trunk provider VoIP Innovations Inbound trunk settings (these same settings work fine on other...

View Article


Can I limit the number of phone registrations?

@edlentz wrote: We are wondering if there is a way to limit the maximum number of phones and or SIP connections on a given system. Say for instance we want to sell a NUC based system and limit the...

View Article

New User - Questions about FreePbx 11

@samarios wrote: Hello guys, i'm very new with elastix and the FreePbx. I install both , and i setup everything . Now i have 2 Bri ISND cards and 2 Analog cards.Everything is working. I made 15 sip...

View Article

Restricting who can initiate a page

@ctiefel2002 wrote: Asterisk: 1.8.15.0FreePBX: 2.10.1.15 We are running this in a school and the students have apparently figured out the paging codes. We have the Paging Pro module on the system as...

View Article
Browsing all 12632 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>