How can an Administrator change Call Forwarding or DND for a user?
@bflinte wrote: Newbie question: Is there a way for an Administrator to change Call Forwarding or DND for an end user? I can see if these features are active through User Management, but the only way...
View ArticleAllow 11 digit CID
@ipserviceskenya wrote: Dear All,Still newbie on FreePBX. This might have been discussed before with no specific answer.Am using FreePBX 13.0.124 I want to allow ONLY CIDs with 11 digits...
View ArticleDID multiple failover destinations
@Vyspa wrote: I have a system where we want to direct each persons DDI to them for 5 seconds, if they dont answer it goes to the main sales queue for 10 seconds. if it is not answered by an agent...
View ArticleVoicemail Oddity
@hiddenvision wrote: Hi All,I wonder if this is a feature or perhaps an oversight. With voicemail blasting I notice that if a group member has a temporary message recorded then the caller hears that...
View ArticleConnecting two PBX's over the internet with IAX trunks
@kwriley87 wrote: Hello This should be pretty basic but I am running into an issue here.I have two PBX's both running FreePBX 12.0.76.3.I have created IAX trunks on both PBX's and the status on both...
View ArticleRoute SIP trunk
@ganiherawan wrote: help me. How to route server PBX non line to server PBX any line to call phone number ?? thnks Posts: 20 Participants: 3 Read full topic
View ArticleIssue with calling external numbers in ring group
@rco wrote: I have a ring group that calls four internal extensions and two external numbers in 'ringall' configuration. When I call the ring group extension, all internal extensions ring, but the...
View ArticleGmail as postfix SMTP relay in CentOS 7
@amztransit wrote: Followed these instructions: http://charlesauer.net/tutorials/centos/postfix-as-gmail-relay-centos.php And still having trouble. Trying to set this up so that I can send emails out...
View Article"Close" and "Open" an extension to dial dynamically
@orkwizard wrote: Hi Everybody, This seems a really active and helpful community. Im pretty new to FreePBX so im sorry if i make a newbie question. I work for an hotel which has finally accepted that...
View ArticleHow to protect my SIP Trunk Connection?
@ganiherawan wrote: how to secure a server with a sip trunks of the user or an outsider trying to break into the server . to my server using linux cent os. Posts: 1 Participants: 1 Read full topic
View ArticleModules: Best Practices, Minimum Required, Etc
@dsgii wrote: Using the latest FreePBX distro (10.13.66-12) and I have been noticing something I just don't get. Commercial Modules that require a license to function: Do these do ANYTHING other than...
View ArticleCisco SPA112 Fails to Register on FreePBX 13
@andrew_miller wrote: Hello, I have FreePBX 13.0.124 installed and working with a number of Yealink and soft phones. I've purchased a new Cisco SPA112 and upgraded the firmware to 1.4.1(002) as the...
View ArticleHow to use different Outbound CIDs for different outbound routes
@gatozgz wrote: Hello good morning, I have a doubt about that: How I can use different Outbound CIDs for different outbound routes.It is not as easy as looks like to be, im going to show you an...
View ArticleBRI PRI calls timeout cause 18
@al2lo wrote: All calls timeout with cause code 18 gave by DAHI. The debug info is below: Have replaced card after lightning and still no luck. Wanrouter Status: Device name | Protocol | Station |...
View ArticleIVR + Announcement can't hear audio
@garethqct wrote: Hi All, I'm just in the process of setting up a new FreePBX 13 box installed on a MS HyperV box from the FreePBX-64bit-10.13.66 iso. It's to replace an old install that we have been...
View ArticleCalled ID not working after module(s) updates and orderly shutdown
@translux wrote: I'm a bit over my skis on this one.After updating several modules followed by an orderly shutdown we initially lost inbound/outbound service. I was so panicked trying to restore I'm...
View ArticleFinding balance with the FCC Robocall list
@jfinstrom wrote: There has been much discussion over the FCC robocall list and why it’s the greatest thing since canned bread or why drinking bleach would be a better choice. Current implementations...
View ArticleAastra phones resetting to factory occasionally
@bksales wrote: There are two offices, both connecting to the same hosted FreePBX virtual instance. Once a month or so a couple of the phones will go offline and when we look at it the phone appears...
View ArticleFreePBX 13.0.124 (distro): Emails to asterisk user: various errors
@TugBoat wrote: Following installation of the FreepBX 13.0 distro I am getting some emails delivered regularly to the asterisk user. I don't exactly know if these are 'normal' or not, so I thought I...
View ArticleWhere/what is all the disk activity?
@TugBoat wrote: Firstly, I should say that this is not a complaint - it is more that I would like to understand something that appears unusual to me. I am running FreePBX (13.0.124 from distro) in a...
View Article